Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums
Filter by: Last 7 Days Clear All
  • phil_o's Avatar
    01-26-2023, 09:55 AM
    I have a Shopbot PRT, with a 4g Board, circa 2006. Works great. This is the PP I use. I have Aspire but that should make any difference. Phil
    14 replies | 3907 view(s)
  • Mike Windsor's Avatar
    01-24-2023, 08:05 PM
    I'm trying to figure out what's going on with my indexer . first time using it . I created a rounding toolpath in aspire V11.5 and have the indexer...
    0 replies | 54 view(s)
  • srwtlc's Avatar
    01-21-2023, 04:20 PM
    srwtlc replied to a thread Odd noise in ShopBotter Message Board
    Good catch Russ! Yes, if the font wasn't created in VCP, but brought in from another program as a dxf etc., you can get many nodes that then create...
    6 replies | 256 view(s)
  • chiloquinruss's Avatar
    01-21-2023, 11:18 AM
    Another area to look at is the actual toolpath created by that font. If you select the vector in node mode the font curves should be just a few...
    6 replies | 256 view(s)
No More Results