Activity Stream

Depending on what you're doing you can either upgrade, or take a look at Fusion 360. It's free if you're a hobbyist. It's more meant for metal mills,...

Agree that the 5/8" thick panel is a bit thin for the contours shown in the rendering but the door thickness mandates 5/8" panels. The panels will...

The rendering panel is a lot thicker proportionately in appearance then 5/8". Done in 5/8 much of the dramatic effect will be lost. Another issue...

Here is the picture and drawing.

The reason you are able to get a discounted rate on the SB version of the software is because it only supports ShopBots! To upgrade the current...

Practical aspect also. Had a friend lose his entire shop to fire....hand carver, but all his big iron was downstairs in the basement, and...

Gert is always a tremendous help...I'd take him up on help! BUT, you might also like to at least be aware of Paul Rowntree's "Standing Wave "...

Obviously wave objects have many variables, like size, resolution, wavelength, amplitude, plain or circular etc... I have a tool to generate a...

Thanks for all the inquiries. This machine is sold.

Have you check the Vectric site they have tutorials on how to make textured panels

>> I'm not sure it's a matter of discipline or a matter of having the time available to do such a thorough cleaning. I'm sure that's the case....

The Shopbot was originally made to cut boats so I would say yes it will do the job.

Good point. I've actually found the joint to be quite good even when humidity is up. But right, also the spoilboard condition and another dozen...

I'm not sure it's a matter of discipline or a matter of having the time available to do such a thorough cleaning. As soon as I finish a project, I...

>> 0.001" repeatability A change in humidity would render that kind of accuracy moot in wood.

Dito the "impressive". I too try to be as meticulous but have not achieved your level of perfection.

You're going to hear a lot of different views from a lot of people here, and likely just about anywhere else you ask. My advice is to see if you can...

Magic John! All you need for perfection is a couple of Teslas and a nice Powerwall blinking away!

it would have even been easier to cut these out of stock with just a hole in the center and the outside what you want and stack them together with...