Activity Stream

Jut had a look and the LEDs on the main board and the piggy back board that the USB lead is connected to are on.....not blinking though. The fuses...

Thanks guys......I’ll check the power supplies.....looks something has failed so will be contacting SB The controller does have a small board piggy...

Sold thank you!

Sold thank you!

Set pinions into rack with a scale to make sure we have recommended pressure into rack. What is curious is I only get this serration in the X axis...

Does your controller have one of the USB to serial adapters (little pig tail kind of thing)? Those go bad as well now and then.

I would drop the steppers and run them while I move the wires may be a broken wire

Yeah I have had the same problem. Easy to check with voltmeter.

One more thought would be to swap the drivers for your x axis steppers and see if the problem moves to the other side of the table?

I had a similar issue recently. When I powered up, my motors would clunk and lock properly, but no comm with the computer. My problem turned out to...

"Spits the dummy" What on earth does that mean? Ahhhhh now I see -- that must be an Aussie expletive! Inside of your control box will be a...

The cost of the different programs is actually challenging to determine without being very careful you are comparing apples to apples in the output...

https://www.cabinetplanner.com/

Try contacting Gary Campbell or Brady on here and see if they would be willing to come fix it. You will probably save money in the long run paying...

Thanks for this. One thing I am not is penny wise and pound foolish. If buying something makes sense and is costly, I will do it. Having learned i...

Vectric is a drawing/cam software and has no code directly related to cabinets. You would simply be drawing or importing your part drawings and then...

Be sure you've set the pinion gears tight enough. That's what it looks like to me. Since you're pushing them up to get them set, it can take a lot of...

It looks like we are going to need a few more training sessions on 3D carving! We only scratched the surface today in our two hour training. We had...

Thanks. AND I just realized that this is posted in the wrong section. I'll pass this along to my IT guy. And repost properly.

Serrated edges on all cuts on hdpe. Did not change feed and speeds which have been working fine (some serration of edges but usually only in curves...

Sorry for your headaches Ken! But let me be the first to ask that you post some clear, up close photos. Any trouble-shooters will want to see...

I have the same issues as QMI and have gone through ALL (I think) the steps recommended. For my PRS Alpha the worst chatter is in the X-axis. It is...

I've been using eCabinets for 10 years now. I build about 200 cabinets a year, in a one-man shop. I've developed a whole seed library based on how...

I've been cutting cabinet parts for 10 years with a 2.2hp spindle and have never had a spindle problem (knock on wood). Of course, now that I've...

Bleeth, Thanks for the explanation. I currently cut about 8-10 cabinets per month but have the opportunity to make carcasses for others in my...

Also, the spindle is only 6 months old.

I looked at your post, and like others have said, I passed on because no pictures, and price too close to new. Like Brady said, the 60% of new is...

Thanks everyone for the great advice! I think this project is going to be as much fun for Carol as it is for me! CG thanks tons for the offer to...