Activity Stream

Not to derail your search, but why SprutCAM in the first place?

Hey Steve, just sent you an email with the files!

Thanks robtown I was looking under the on/off toggle and there it was....... it was pinched wire that was causing the short on the new router. I...

Let me know if it works for you. I was able to eventually figure out how to get a line of code inserted into the MTC file that will automatically...

Jay, When entering this life time adventure I bought a router with the notion of cutting letters and panels. Why not cut letters and sell them to...

I might be having the same issue, I will try setting the variable to 1.

I can. was trying to figure out what I can do with it after I make it. I have aspire 9

Thanks.. for the kind comments.

My first PC router lasted about three years, my second a year or so, my third is still going about 7-8 years later. My current router (the third...

Have to ask… any chance wiring changes caused 220 to be applied to a 110 router? SG

Hello Tim ... I took a quick look at the brushes because thats one of the few things I know of that would cause the router to stop like this but they...

Have you checked the brushes, I know you said new one but just had to ask

That's really cool, at first I thought you copied my ear :p

Hello Bob...right now my router doesn't turn on at all anymore. Is that normal for the router to completely break once the fuse blows? I would think...

I would start with an amp meter on the router with no load. Then check it under the kind of loads you typically use. An electrician can help you...

Any other takers? It's best if you have Aspire/VCarve 9 so you can open the files. There is a properly layered DXF too you can bring into an older...

Thanks for the quick reply Gary. hmmm you may be right. The first router I worked it pretty hard over the years. I only build certain snapped items...

Any chance that the problem is the load and RPM combo that you are operating at?

Hey Joe, When it comes to signs, you are definitely the master signmaker!! I would love to begin doing some signs and believe there may be a...

Okay, I am lowering the price to $8800. I won't be offended if someone wants to make an offer.

I never thought there would ever be a Micro-Brewery fad that would go up against giants like Bush and Budwiser. As we all know that's a huge and...

I run into a error with too many parts in aspire. if there were a couple hundred I could not select them all or I would get a error. wonder if the...

thank you!

Current version, 3.8.42 is 10,000,000. Not sure what version it was, but it was lower and I did run into it on a large 3D file once several years...