Activity Stream

I just upgraded. I was on Aspire 4.5 so going to 9 is a good jump for me. I'd don't like going more than one version between upgrading just makes...

Oops on 50MB new clipart for VCP9 :( That's Aspire only. Sorry, scott

Good vid TJ, But you totally spaced mentioning friction tabs(Like I spaced on class today). :) I'll have to avoid playing hooky:) scott

Thank you everyone today for your participation. A lot of new faces today! Enjoy! https://youtu.be/TCME1u9UPCg

I need a way to speed up the video. I could only get through about 3 minutes of 1:17:00 (OMG) It seems to belabor a continually disappointing UI. ...

Has anyone seen or used these: http://lockdowel.com/

Please send an email to me at tom@lempicke.com If you send it from your regular e mail account we can communicate

https://columbus.craigslist.org/tls/6210488494.html

https://www.youtube.com/watch?v=er-9RlnNAXU oops... that's Aspire https://www.youtube.com/watch?v=T2Eg6CzBmQE here's VCP

I doubt I will update. last time I had 6 and they gave me a deal to go to 8 that was a lot cheaper. I don't end uo using a lot of the new features. I...

Steve...Gary Campbell just said on the Vectric forum; "My downloads included nearly 50 MB of "V9" additional clipart" That was in the Aspire thread...

Yeah Steve, VCP8 was wonderful, and 8.5 was a game changer. Not that much I can use either....but playing with the 2 sided and the icons now(and...

Got it. I assumed you knew the guy and situation first hand, sorry. I never run my router while I am not in the shop. I might not be staring at...

It gets sent directly from Lamello in Switzerland. It came pretty quick. You get a pack of 8 connectors, a pre installed block with 2, and a...

where did you find the video?

Overly optimistic Kyle:) Jerry, Haven't cut much Purpleheart in last 2 years, and you didn't say if it's a 2 or 3 Flute bit. What is size and...

Thanks. I just ordered a sample pack from the website you listed.

scott will tell you

Scott… I watched the hour + video on the V9 features… My first impression: compared to version 8, I’m underwhelmed. Most changes, to me, seem to...

I'm downloading the trial version of VCarvePro now to see the changes; http://www.vectric.com/products/vcarve/trial.html

Wow! This is an awesome set of responses! Thank you everyone! I might give this a shot out of MDO... I've been wanting to try that stuff out for a...

A quick note about the upcoming CNC Seminars event in Melrose Fl, Sept, 14-16, 2017 https://cncseminars.com/events/melrose-fl/ The schedule will...

Andrew... It was a video posted online. Other than what I can observe, there is no more information on it.. No vacuum, no dust, just a couple...

So the actual fire started from the friction between the router collet and the material? Wild stuff. What was the cut suppose to be? Material? ...