Help
Remember Me?
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Forum
Register
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Filter by:
Last 7 Days
Clear All
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Yesterday,
09:55 AM
phil_o
replied to a thread
Did I just waste $700?
in
VCarvePro and PhotoVCarve
I have a Shopbot PRT, with a 4g Board, circa 2006. Works great. This is the PP I use. I have Aspire but that should make any difference. Phil
see more
14 replies | 3899 view(s)
01-24-2023,
08:05 PM
Mike Windsor
started a thread
indexer post processor
in
Troubleshooting
I'm trying to figure out what's going on with my indexer . first time using it . I created a rounding toolpath in aspire V11.5 and have the indexer...
see more
0 replies | 48 view(s)
01-21-2023,
04:20 PM
srwtlc
replied to a thread
Odd noise
in
ShopBotter Message Board
Good catch Russ! Yes, if the font wasn't created in VCP, but brought in from another program as a dxf etc., you can get many nodes that then create...
see more
6 replies | 239 view(s)
01-21-2023,
11:18 AM
chiloquinruss
replied to a thread
Odd noise
in
ShopBotter Message Board
Another area to look at is the actual toolpath created by that font. If you select the vector in node mode the font curves should be just a few...
see more
6 replies | 239 view(s)
01-20-2023,
12:00 PM
Slant
replied to a thread
For Sale: 2015 PRS Alpha ATC 4'x8'x8" +Vac Table + Single Phase 5HP Spindle - Nice!
in
For Sale/Wanted - ShopBot-related items only
Dropping price again! Motivated to sell! Asking $19,950! I can help with shipping and installation. Give me a call or text anytime! Josh 530...
see more
2 replies | 1075 view(s)
More Activity
No More Results
No Recent Activity