Activity Stream

I've planed plenty of slabs on my SB and I've found that very little hold down support is required. As long as you don't try and take off 1/4" at a...

OP, I still like your table!!! Good job and thanks for pointing out the gadget. Gerg

I have used screws from the underside of the table, along with wedges strategically placed to keep the slabs as parallel as possible. Phil

Here's another video of doing something like this stackable crate: https://youtu.be/Ld7zXmhYoDM Here's the source model I used from SketchUp: ...

Why stop at the box gadget? What if you could make anything that you could design and turn it into ShopBot code in seconds: ...

Man the box gadget is pretty dang good. Hats off the the creator. I nailed it the first time (still can’t believe it). I just exported the file so I...

Monty… I was working on documenting my method of making boxes with box joints on all edges in case we ever had another “Camp ShopBopt” I was about...

Wait a cotton picking minute! There is a box gadget? I am using Aspire 9.5 and I don't have a box gadget! I painstakingly modded and modded and...

can someone tell me if this is still used with e-cabinets?

can someone tell me if this is still used with e-cabinets

OP, Nice Paulk table!!! Greg

It sure is! I've modified the hell out of it, totally new drive system, aftermarket control, custom designed 8 zone vac table, automatic tool...

Eric, is that the machine you bought from me??

Sorry for the late reply, just saw the thread. IDK if this will help you but Dan Swatski, a well respected sign artist (one of the few people in...

Wow! That's an amazing work of art. I'd bet that it will still be as amazing in 100 years.

The red oak one out of old church pews the cross is reclaimed chestnut.

The finished tulip poplar one.

Yes, I will ship it to you if you pay for the shipping.

I have one, purchased in 2013 but low hours. It comes with a Dell computer & monitor with VCarve & PartsWorks software running; 20 carbide carving...

Sorry KurtR, it has been sold. I forgot I even posted it here. Sorry

I haven't checked this forum in a long time.. Sorry.. I went with an Acorn system from Gary Campbell. I upgraded to closed loop Steppers as well.

Fusion 360 definitely has a learning curve. SketchUp is far easier to learn. There are advantages to both. If you absolutely need parametric design...

Did you sell your control system Plasmadrive?

Seems simple enough but it was all I could handle at the time.

Yep the dust shoe... Most definitely, I'm trying to get Fusion360 figured out. It's quite the software to learn from scratch but i have a few...

Are you talking about my 3D printed shoe? Also, would you ever consider using something a little more robust than the box gadget? ...

By the way your dust boot setup is awesome. I might have to adjust my spindle to get it to fit or just make a few mods in Fusion! (I have it printed...