View Full Version : Archives2008

  1. Height issue in shop -- What is minimum vertical clearance required?
  2. Surfacing table
  3. Hints for attaching spoil board to Buddy table?
  4. HSD Spindle warm up/cool down
  5. Contactor not engaging without help
  6. Floor , plywood or concrete ?
  7. Table sides
  8. Spindle maximum working temperature
  9. Surfacing Spoilboard - Acceptable tolerances?
  10. To bolt or not To bolt... to the floor...
  11. Quick Question
  12. Energy Chains don't mesh with Dust Collection?
  13. Aligning Z-axis to table
  14. Disassembly of PRTalpha
  15. After 3 years the bearings finally went out on the Porter Cable
  16. Missing screw
  17. Getting the Z axis to plumb
  18. Looking for a nice piece of wood?
  19. Shop Bot Dust Control
  20. Brown wire for 2.25 hsd spindle
  21. Could you Mazerati guys help out a Geo-metro dude?
  22. Moving Through Doors
  23. Buddy 220?
  24. New PRS
  25. Bleeder board longevity
  26. TruPan
  27. Gasketed Plenum
  28. Wiring Up a PRTalpha
  29. Help Assembling PRS 48X96 in Denver Area
  30. Single Phase power source
  31. Wago connector part number
  32. What is the best way to lube this thing?
  33. Two years into working with the PRT... what to look for?
  34. Table surface
  36. Vacuum Requirements