PDA

View Full Version : New computer



mikek
02-18-2008, 08:40 PM
Just installed another computer to replace Vista based computer. Loaded all the latest software, SB 3.5.5, Partworks, Partworks 3D, VCarve Pro 4.0, AutoCAD LT 2000i, etc. Everything works a LOT faster and with no problems versus Windows Vista. This P4 2.4GHZ machine has Windows XP Pro and is OK.

I am having a ShopBot problem with using the C3 command. It zeros the X axis and backs off the prox switch to X=0, but the Y axis hits the prox switch, backs off, hits it again, and then moves in the negative direction, and stays in the prox switch window. I can move it off and everything is OK until it goes back to Y=0 and it is in the limit switch again. What have I overlooked? Thanks

mikek
02-20-2008, 08:08 AM
Ryan at ShopBot asked me to check the offsets in "setup". The y axis had a positive value in it. Putting a negative value in it corrected this.