supertigre
10-08-2010, 09:51 PM
I just downloaded 3.6.24 and loaded it on my controlling computer. I also updated the software on the control box (4G).
When I run JH and then J2 96,24 it smoothly ramps down at the end of each move.
If I run JH and then J2 96,24 and push the eStop just as it starts to move and then "Resume" it crashes to a stop at 96,24. There is no ramping down, it just goes from full speed to 0 instantly (or as close to instantly as a gantry moving at 8" / sec can stop).
Can this be addressed in the next update, please.
Guy
When I run JH and then J2 96,24 it smoothly ramps down at the end of each move.
If I run JH and then J2 96,24 and push the eStop just as it starts to move and then "Resume" it crashes to a stop at 96,24. There is no ramping down, it just goes from full speed to 0 instantly (or as close to instantly as a gantry moving at 8" / sec can stop).
Can this be addressed in the next update, please.
Guy