View Full Version : Going Bigger...
ATX Poly Products
03-25-2011, 09:26 AM
I just got all the parts from ShopBot to turn my 48x48 into a 96x48. All assembly is done as of this morning...
My question is what all parameters do I need to change in SB3?
Thank You
bleeth
03-25-2011, 02:59 PM
In Tools is the Shopbot setup program but it won't let you change your type of SB andf table size. You will have to do that from the my_variables.sbc file on C drive in the SB Parts folder. I will repeat SB's warning: Be very careful here.
Otherwise you can un-install and re-install and run new set-up.
srwtlc
03-25-2011, 03:33 PM
You could just do a UR (Utilities Reset), follow the prompts and then choose the machine size you now have.
bleeth
03-25-2011, 03:46 PM
That's a better way Scott: I didn't know that command.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.