PDA

View Full Version : SBLink (metric) plunge speed oddity



dkrage
01-09-2012, 05:46 PM
Hi All,
Having some unexpected behavior as I get the eCabs>SBLink>ShopBot workflow going and am looking for a forehead slap...

When I send a nest to the SB via the link my drilling plunge speeds are 1/60 of expected. If SB3 set to 100mm/s, and SBLink plunge rate set to 100 (% I assume, as there are no units noted), I get 1.67mm/s speed.

Question: Do I simply enter all feeds/plunge rates in mm/min?
OR, do I have something else sinister haunting me?

The collective TalkShopBot wisdom forthcoming would be greatly appreciated...
Thanks in advance
Dan

garyc
01-09-2012, 07:28 PM
Dan...
You are correct. Feed speeds in the SB Link are set in Units/Min.