Particle board motorcycle

[keitaka1]

This motorcycle was a test cut that I made from a file that I purchased from Fabrice by mistake. This is the motorcycle portion of the (motorcycle rocker) file. Fabrice sent the file to be cut from 3/4" material, but since I had a 4'x4'x1/2" sheet of particle board sitting on the bot, I modified the file and cut this. Not enough material for the rocker portion. 28"W 13 1/2"H

[billp]

Sheldon,
Great project photo! Your setup made particle board look good!

[Brady Watson]

Nice!

I thought you would have engraved 'Papa Wheelie' on the tank or something :D

-B

[myxpykalix]

That looks like an American Choppers original.:rolleyes:

[upsman]

Sheldon, Where did you get the file? I am working with a motorcyle club for a sign. Can you post a link to the file. thank you

Tim

[zeykr]

Fabrices page is at http://fabrun.pagesperso-orange.fr/

[mtylerfl]

That's a great project, Sheldon! Particle board never looked so good!

[genek]

How big is the motor cycle

[keitaka1]

Thanx Guys. Eugene, the dimensions are
28" wide
13 1/2" high
4" deep