PDA

View Full Version : Valet enclosure



steve fedor
07-23-2012, 07:02 PM
Made these removable panels from Cedar, 1.5" steel angle w/ weld nuts to attach the panels and .177 cast acrylic. Measured all the opening and was surprised @ the accuracy considering this building was constructed over 100 yrs. ago. I made a card board template of the curved brackets and added tic points to aid in drawing and cutting the curves in Aspire. The acrylic was cut on the Bot. We added their logo in frosted calandered vinyl to each opening and a 220v heater. The building is located on Lake Erie.

myxpykalix
07-23-2012, 11:31 PM
Measured all the opening and was surprised @ the accuracy considering this building was constructed over 100 yrs. ago.

It is precisely BECAUSE it was built then that it had the craftsmanship and accuracy in it. Had it been bult 20 years ago....forget it!:rolleyes:

Very nice work.