jwa1156
02-23-2014, 05:22 PM
Have had my desktop for 7weeks,
have been working fine until today
when I attempted to start the ShopBot3 Control Software
received error message below
Have re-butted PC & CNC
Have un-installed the ShopBot Software and re-installed,
The 2nd install went with out error
received same error message
Message
Run-Time Error "76"
Path Not Found
Any ideas and fixes will be
have been working fine until today
when I attempted to start the ShopBot3 Control Software
received error message below
Have re-butted PC & CNC
Have un-installed the ShopBot Software and re-installed,
The 2nd install went with out error
received same error message
Message
Run-Time Error "76"
Path Not Found
Any ideas and fixes will be