seat file for VCP v 7.0

[Stephen50]

Can a seat profile be made with VCP not Aspire? I've reviewed previous forum topics and haven't discovered anything related to my inquiry, I might be looking in the wrong place.

[Brady Watson]

A 2D profile can be done in VCP. A 3D relief toolpath can be imported into VCP after it is toolpathed and saved in PartWorks3D. It is a bit clunky, but can be done. You cannot create a 3D relief in either program. You would need the SB probe or a 3D file to start.

The ideal tool for the job is Aspire. Contact ShopBot directly for discounted pricing on upgrading to Aspire.

-B

[scottp55]

Stephen, Did you grab the .crv and .eps from Vetric forum with the fluting toolpath for VCP7.0 ?
http://forum.vectric.com/viewtopic.php?f=5&t=18037

[scottp55]

Stephen, I didn't know there was a tutorial until this morning about it.:(
http://support.vectric.com/tut-vcp-feature-reference