PDA

View Full Version : error message: reset stop switch



Hoytbasses
06-12-2014, 11:43 AM
I have NO idea what/how the student did this but while zeroing the Z something went awry.

error message says to reset the stop switch: how do you do this on the desktop? I looked in the SB help files and can't find a reference to this.

thanks!

Karl Hoyt
Nauset REgional High School

Brady Watson
06-12-2014, 11:49 AM
Karl,
Cycle the Desktop power & restart the computer to see if this fixes it. If not, then goto the VN command and change the E-stop to the opposite state (open if closed; closed if open [closed is default]) and see if that fixes it. If you open & close SB3 again, and you get the same message, try switching states again.

If you are unable to get it to work at all, carefully inspect the wiring for the E-stop and make sure that the cable isn't damaged and that it is properly seated in the control board. As stated, it *should* be setup as Normally Closed type of switch so that it would trigger an e-stop condition of the wire is severed.

-B

Hoytbasses
06-12-2014, 12:38 PM
thanks: will try it and report back

kfh