Help with Part Wiz

[sleepy]

I have a bench top and make signs, I design in corel, export out as a dxf file and import into wiz. On some fonts Occasionally,One font will not be red like the rest, it will be black, and a small circle will be on this font. How do I correct this.

If I tell it to do the tool paths it will do all the red fonts but not the black one with the circle on it

[bjwat@comcast.net]

David,
Generally if you see a small circle like that, it is because there are overlapping vectors at that location. (Took me a long time to figure that out too!!!)

Just zoom in as far as needed, and edit the affected nodes until none are crossing over.

-Brady