kivimagi
09-25-2005, 03:47 PM
Folks,
Went out to spend some quality time with the bot today, and succesfully zeroed the z axis, and then loaded a part file.
To make a long story short, I accidently ran a part file configured for a torch, rather than a router, and my z no longer works.
Could this have blown the driver, or did I muck with a setting when accidently running in this mode?
I've contaced support, but I'm curious if anyone has any info for me to get me going today.
Regards,
Went out to spend some quality time with the bot today, and succesfully zeroed the z axis, and then loaded a part file.
To make a long story short, I accidently ran a part file configured for a torch, rather than a router, and my z no longer works.
Could this have blown the driver, or did I muck with a setting when accidently running in this mode?
I've contaced support, but I'm curious if anyone has any info for me to get me going today.
Regards,