PDA

View Full Version : Z cuts deeper going down X than coming up X



panelman
08-09-2004, 12:39 PM
My PRT96 is cutting about a 32nd of an inch deeper going down the x axis than it is coming up the X axis. Discovered this while tring to find the lowest point of table so a could level top. Any thoughts.
Thanks
Frank

elcruisr
08-09-2004, 05:20 PM
I had this happen when I first set up my machine. We found it was a problem with power wires to the router bundled with the control wires to the motors. Make sure they are bundled seperatly.

Also insure that your grounds are good, including dust collection hose. That can cause errant moves.

After that call the support line, they have dealt with all sorts of issues like this!

Eric

panelman
08-10-2004, 09:05 AM
After taking most everything apart and realigning, retighting, and seperating wires the problem is gone. Don't know what part solved it because it was all done at the same time. Thanks Eric.

Frank