zeke
06-07-2009, 03:36 PM
I'm having a problem when entering move / jog commands, the coordinates move and the Bot does not. It's a new PRSstandard and I drilled my table holes yesterday without an issue, how nice was that to have the Bot cut the holes!
Although....
When I was going to cut the recessed bolt head holes today, I received an error, my fault apparently. I guess Partworks will allow you to set some speed parameters outside of tolerance, but then the Control software will not. I had a setting that was too low and received this error "Parameter Value Below Range for VS- Setting to lower limit (.05)".
After that my machine lost it's X and Y position and lost it's mind. When I entered move commands, the coordinates moved but no machine movement. Another thing I'm not sure about is that last night I added a USB mouse to my laptop, the mousepad was not working very well. I'm not sure what is causing my issues. I did disconnect the new usb mouse. Turned everything off down to the breakers to clear everything. I left the mouse off the laptop and went back to the mouse pad just to be sure I wasn't introducing a problem with the new mouse. Turned everything back on and the Control software is still moving the coordinates, but the machine itself is not moving.
Has anyone run into this, any suggestions?
Guess I can't update the title, I noticed I had a spelling error in it after submitting....
Although....
When I was going to cut the recessed bolt head holes today, I received an error, my fault apparently. I guess Partworks will allow you to set some speed parameters outside of tolerance, but then the Control software will not. I had a setting that was too low and received this error "Parameter Value Below Range for VS- Setting to lower limit (.05)".
After that my machine lost it's X and Y position and lost it's mind. When I entered move commands, the coordinates moved but no machine movement. Another thing I'm not sure about is that last night I added a USB mouse to my laptop, the mousepad was not working very well. I'm not sure what is causing my issues. I did disconnect the new usb mouse. Turned everything off down to the breakers to clear everything. I left the mouse off the laptop and went back to the mouse pad just to be sure I wasn't introducing a problem with the new mouse. Turned everything back on and the Control software is still moving the coordinates, but the machine itself is not moving.
Has anyone run into this, any suggestions?
Guess I can't update the title, I noticed I had a spelling error in it after submitting....