View Full Version : Error message in partfile

04-06-2003, 07:32 PM
When I run a partfile in shopbot it just stops after a while. When I run the partfile through Prewiew mode it says "Error line ..." When I open the file in notepad, I can't find anything wrong in the code.

I use Mastercam v9 to generate paths. I have upgraded the post-prosessing file. Normally there is no problem running the part files, but when I use toolpath-finnish-surface-shallow(mastercam toolpaths) I get the error.


07-23-2003, 02:38 PM
I have not been on the forum in a while and found your message about the error you were getting.
Were you using the MPSHOPBOT post or a generic Fanuc style post?
Either way if you had tried filtering the toolpath and a circular interpolation was in the XZ or YZ toolplane the Shopbot control wont support that kind of arc motion.
I hope this helps.