Run time error '9'

[casey_h]

I am getting what is called a run time error '9' and a meassage that says subscript out of range when i hit ok on it i get booted out of the shopbot control pannel. After i get back into the program the panel says i'm in a location that is not where the router really is so i have to re-zero all 3 axis.is this a file error or a comp glitch? i am running sb3 control software with a 4.17 board.any advise would be great thanks

[j_limoli]

Im having a simalar problem. Only once I load the Sb3 the run time error '9' appears with the same message. The error will not even allow me to open Sb3 software. If you have discovered a solution, or have any insight it would be much appreciated to find some help.

John

[tomf]

I haven't seen anyone post a solution or suggestions for this Run Time Error '9' issue. Anything new on this ?? I see it on my shop computer on a large finishing file - even in simulation mode - but not on my office computer in simulation mode. Could it be memory size related ?