Positon Console

[nat_wheatley]

Is there a way to move, or least minimize, the rectangular red 'Postion' console?

[blackhawk]

Here is a thread talking about this
http://www.talkshopbot.com/forum/messages/312/20824.html

[beacon14]

Here it is from the horses mouth (no offense intended Ted). Scroll down a little to October 2008.

Ted's report (http://www.shopbottools.com/teds_report.htm)

[srwtlc]

Nat, see if your video card drivers/software offer the option to have multiple desktops and assign one to SB3.

[nat_wheatley]

I have a second computer that I've planned to set up just to run the SB. Foolishly I hadn't considered that the fixed console position won't be an issue once I do set up the second computer. Thanks for the posts.

[cncworld]

Hi all, here is how I deal with that issue.... Although one can still have another computer for there Partworks software, or whatever they are using. I find it necessary to have it on the controller computer, so I can do fine adjustments, but never while the machine is cutting....

So I just adjust the screen size to fit around the positioning console. Since I use a laptop, I still use the controller computer to do major programming, usually away from my workshop.