View Full Version : Digitizing Probe Surface Tolerance

07-03-2006, 11:09 AM
On the probe fill in sheet in the Copy Program, there is a box with the Surface Tolerance. Where can I find an explaniation for this setting? Thanks

07-03-2006, 03:38 PM
Hi Robert,
This is the amount that the probe pulls up after making contact with the surface before moving to the next step. Under c:/programfiles/shopbot/shopbot3/virtualtools/copymachine you will find a FAQ doc about running the probe.

07-03-2006, 06:07 PM
Thanks Scott, I will look this up tommorow!