PDA

View Full Version : Parameters



bill1
04-20-2009, 11:31 AM
Does anyone know where is the best place to get Cutting parameters,
speed and feeds for new tools being put into theTool Database.

jerry_stanek
04-20-2009, 05:56 PM
Onsrud has it in their catalog

benchmench
04-21-2009, 12:50 PM
For Onsrud (and most others), you can fine chip load data Here: https://www.onsrud.com/xdoc/FeedSpeeds

powerlsc
04-21-2009, 03:52 PM
Dan,

I have a new shopbot buddy and purchased several bits from them with the order.

When I'm ordering from Onsrud which bits should I be looking for if I plan to work primarily in HDU? Are the bits under the "foam" catagory referring to HDU?

Also while I'm asking newbie questions, is there a guide that shows which bit is used for which cut or application. I am really just used to hand carving out everything.

Thanks,
Lynn

bernott
04-21-2009, 06:00 PM
homeagain try this link, http://www.talkshopbot.com/forum/messages/29/38343.html
it's a start then fine tune to your needs.

lynn get the bit mfg's to send a catalog. lots of great info also, as far as HDU any soft wood bit will work and work well.