PDA

View Full Version : V15



nat_wheatley
09-21-2009, 08:49 AM
I ran a sheet of parts earlier today and had an issue with the cut depth (several different depths for the profile cuts, none of them all the way through). If you're cutting with V15 for the first time, as a precaution, take a look at the code and check you Z-depths before actually cutting.

It may be that I have a setting off, and that its not the software, but I don't know that I changed any settings since cutting successfully with V14.

I have sent the file to Thermwood.

nat_wheatley
09-21-2009, 09:38 AM
I'm told the code looks correct. Checking my machine...

Gary Campbell
09-21-2009, 05:15 PM
Nat...
I cut a partial sheet today (V15)and didnt have any depth problem.
Gary

dlcw
09-21-2009, 05:55 PM
I cut 5 sheets of 5/8" baltic birch on Sunday with V15 and didn't have any depth of cut problems. Had a few parts slide around during cutting but I guess when you don't resurface your spoil board after cutting 100 sheets you deserve it... :-( Live and learn....

Don
www.diamondlakewoodworks.com (http://www.diamondlakewoodworks.com)