knight_toolworks
01-22-2008, 01:07 PM
I don’t really use preview as vcarve pretty much tells me what I need to know. But I ran the wrong version of a file (had two copies of vcarve open) so I desided to run preview to just make sure it was the right file.
Well when I started it up the grid was ok but the table shadow was off the home corner like you had an offset going. This was before I loaded the toolpath. Though when I did load it showed in the right place on the grid. But when I ran the file it seemed to have changed 0,0 and cut in the wrong spot and ran into the stops.
But the toolpath was fine and worked ok after I got everything re zero’d. Since then if I ran preview it would crash sb3. I forgot I am running sb3 4. Something the version right before 5
Well when I started it up the grid was ok but the table shadow was off the home corner like you had an offset going. This was before I loaded the toolpath. Though when I did load it showed in the right place on the grid. But when I ran the file it seemed to have changed 0,0 and cut in the wrong spot and ran into the stops.
But the toolpath was fine and worked ok after I got everything re zero’d. Since then if I ran preview it would crash sb3. I forgot I am running sb3 4. Something the version right before 5