chipster
03-14-2009, 07:06 PM
In a prior post, I mentioned that I am getting a re-homed, 2002 96x60 PRT. When I finally get it home, I'd like to take my time and make certain that everything is as good as possible on it.
I'm going to do the g4 upgrade on it, I thought I might as well change pinions, and of course it will be getting a "once over" as I level, lube and square everything. What else should I consider? I'd rather do it now before my first cuts (new vauum table) rather than never get around to it later.
I'm going to do the g4 upgrade on it, I thought I might as well change pinions, and of course it will be getting a "once over" as I level, lube and square everything. What else should I consider? I'd rather do it now before my first cuts (new vauum table) rather than never get around to it later.