This is what we have done so far

[menewfy]

We got the bot home last weekend and got it running on Tue. well I thought I would post a couple of pics.

Tim
1315
1316
1317
1318
1319

[harryball]

Very nice. What holddown method did you use?

[applik]

So Tim how are you liking the bot compared to the CW? (you'll love the fact that you don't deal with all those annoying error codes anymore) You are off to a great start. Keep on carvin.
Shari

[menewfy]

I just used screws to hold down with one in each corner.

I like it alot because even though it is slower than the cw it is way more reliable and therfore will output more. the only issues I have had so far are my own fault by trying to run faster than the machine liked to go.

[rookie432]

Tim I'm impressed with the logo on the imacs sign. That's a fairly fine line for pine. Curious how you accomplished that without tear out. My experience has been "especially in soft woods" that a fine raised line tends to grab and tear out in spots.
Your finished cut is pretty clean too. Much sanding?

Bill

[menewfy]

hey Bill, the imacs logo is not raised nearly as much as the letters I too am impressed that it did not break out, grateful is more like it.

there was enough sanding especially on the outside i used a scroll saw and had to stay away from the edge as to not bugger it up.

Tim

[bill1]

Tim, nice work - well done