Printable View
Ok,
So I've finally got my Shopbot running at our new home.... of course New Mexico... I managed to make a few Christmas gifts today (Chili cutting boards). I've included the "dxf" file. Sorry, the .CRV3d file from ASPIRE (version 2.5) wouldn't load....
My wife is out of town so I texted her a picture. She wants the first "couple" as usual....
Enjoy....
Gerald
Gerald:
Thanks for sharing!
What did you make your cutting boards out of?
Steve
muy picoso gracias!!!
Steve,
I purchased the material from Woodcraft in Oklahoma City. Here's a link to the supply:
http://www.woodcraft.com/Search2/Sea...UTTING%20BOARD
Even though it cost about $30 per sheet, I was able to cut quite a few from each board. I'm planning on cutting other objects and will post those later.
Gerald
Gene,
De nada....
BTW, Your "panels" look awesome.
Gerald
i bet those red peppers are HOT!:eek: it looks like a colored corian?
just checked the link and it says a "polymer"(?)
You might take a look on ebay for .25 thick corian you can buy 12"x12" pieces for 1-2 bucks each Last time i bought some...been a while. That would be way cheaper then this stuff.