After reading all the good things about the Amana 2250, I decided to order one. My question is, when drawing the tool in Vectric, do you just draw it with a 1.5" head, or do you draw the actual cutters on it?
Thanks in advance for any help
Printable View
After reading all the good things about the Amana 2250, I decided to order one. My question is, when drawing the tool in Vectric, do you just draw it with a 1.5" head, or do you draw the actual cutters on it?
Thanks in advance for any help
Enter it as a 1.5" endmill.