-
Tool Request
I've have a number of people contact me and request the return of the BDP008 tool, which is the 1/8" 3 flute tapered tool, 1/4" shank with an endmill tip, 1.5" LOC, 3" OAL. (same as BDP002, 77-102 but as an endmill)
The numbers from contact have not be sufficient to do a qty run but if there's added interest from the forum members then I will do a short run and see how its goes.
These tools are uncoated and expect to be around the $38-$42 mark for the return.
I will try to post an image here later this evening
Gary
-
Is that round on the tip or flat?
-
1 Attachment(s)
An endmill has a flat tip and a ballnose has a round tip
Gary
http://www.talkshopbot.com/forum/att...id=31826&stc=1