-
Fuse or Relay?
Hello,
I have an SB 32 standard Buddy. I went to surface a piece of wood today and had the z zero off the spoilboard not the top of the wood. (Thank me very much) The surfacing bit gouged right into the wood to about 3/16" for about 2-3 inches before I could it the stop. The router stopped spinning.
When I went to run the file again the xyz worked but the router did not start up. I unplugged router and went to direct power source and it worked.
I did some search across the forum and the best I could come up with is a blown fuse or the "relay"?
Could it be anything else? What is the relay? I can't identify it on my diagram.
Angelo
-
Its been a while since i had an issue of one of my relays, so I cant tell you exactly where it is at in the control box. But mine was dirty and just need to be pushed in a few times and the dust blown away. If this turns out to be your issue please post a picture of the exact location.
-
Angelo...
If you cant decipher the schematic, post a picture of the control "innards" and someone will get you pointed in the right direction
-