I am using Aspire 9.5 and am trying to Nest Letters and getting letters on top of each other. What am I doing wrong? See Attachment
http://www.talkshopbot.com/forum/att...id=32072&stc=1
Thanks for your help
Jimmy
Printable View
I am using Aspire 9.5 and am trying to Nest Letters and getting letters on top of each other. What am I doing wrong? See Attachment
http://www.talkshopbot.com/forum/att...id=32072&stc=1
Thanks for your help
Jimmy
If needed I can post the file.
Jimmy
Here is the file
Attachment 32073
Possible to "save as" a .crv?
Aspire file can't be opened by a lot of us:(
Thanks
scott
UNLESS they're 3D letters. But doesn't look like it. 2.5D won't affect nesting.
The KE and RS in both Dickerson's are slightly overlapped. Nudge them apart a bit and it will work.
CRV File
Attachment 32075
Thanks for the .crv Jimmy.
Unfortunately I'm using Shopbot Edition VCP9, and patiently waiting for the VCP9.5*** upgrade, which isn't out yet.
Trust the other Scott!! :) :)
scott
I was getting the exact same thing when I tried that CRV until I split the letters that were over lapping.
Thank you all for responding. I did move the letters where they didn't touch each other, and the nesting worked. But I can’t see why it would stack on top of each other.
Thanks you for your Help
Jimmy
I think that Aspire thinks it is ok to put those letters on top of one another