i have such a program if you need it. i agree with dana tou should try it on your own first
Type: Posts; User: jimboy
i have such a program if you need it. i agree with dana tou should try it on your own first
Thanks guys - I going pull table off the power stick and check both.
Buddy 32 with quick release on side One year old Lite use.
Heres the problem, I noticed some slop in X car. While under power I can move the table back and forth about a 1/16. Gear not seating...
Cool Stuff - Excellent
Jim
I'd say that's perfect ;)
Only one word - COOL:)
David thanks, I knew it was a simple fix. Aspire PostP is in Programs/Aspire so faulty thinking had me looking there. Thanks again
Jim
I have a question that is surly obvious but… I normally use Aspire for all my design work but on occasion have used PartWorks 3.0. My question is where are the Post Processers located? My install...
Nice Job
Jim
Joe those are words of wisdom.
Jim
Gary is right! My only concern was if you download and update it needed to be removed.
Jim
Most likely you have broken it with one of the updates. Look at your update history and see if you applied a Microsoft framework update that may be your problem. Disable it and try again.
Jim
That's a great idea
Jack that's neat.
Jim
I like them. Good Job
Jim
Very nice Stan
Jim
Yes turn-around is going to very important.
Jim
These are all excellent answers.
Jim
Karen, I done this several times myself until I realize V bit does not always mean V carve.
Jim
I made a set for my son and he loves them
Jim
And another move I would make is to call Shopbot and explain your situation.
Jim
I looks like dust = $ to me
Jim
Fire when ready Matt.
Jim
You just never know what will go wrong. I figure my variables as best I can and add in the constants. Then add a profit for the shop and a little padding for the unseen. You can start using cut...
No nothing inbox PM
James