Search:

Hi Neville,

McMaster Carr has it. http://www.mcmaster.com/#hdpe-sheets/=am7f7w

$41.87 per sheet + shipping.

Leon

Thanks Joe, learned it all from you. I like that Liver of Sulfur too, especially on the bronze. You're right about the rust running down the wall. I did some house numbers for a friend and we...

Hi Bill,

Thanks for the compliment. I'm located in south central Kansas. Yes, my shop is heated. I'm a wuss, I like it at least 70 degrees. I really can't tell the difference in the two...

Steve,

You might try putting on the patina on the iron before it is completely dry. That has been working very good for me. I normally use the Light Green patina but have also use the...

Nice going Gary, Congratulations!

Absolutely Stunning!!

WoW!! Nice Machine! I'll get busy here and we'll have enough orders for a load soon. I assume this interrositer does both round and square holes.

Hi Joe,

I helped some on this project but mostly on the one you just replaced with the HDU/EPS sign. All great fun and so very educational, thanks.

I guess I should apologize for...

Looking Good Joe!

Fantastic work Joe!

You can't have Too Much memory.

Neville,
Thanks, I'm doing fine. You will like it. Get's you away from using a thumb drive to transfer files.

Hi Gary, how's it going, have you unloaded the Ark yet or is it still...

Hi Neville,

I have mine set up that way. You just need a router and it's pretty painless to set up. Since you already have the cable run, you wont need any of those wireless adapters. You...

RB,

That is exactly how mine works, I just don't have it programed to the software. I just switch it on when needed and switch it off when not in use. Of course mine is battery powered. You...

Bob,
I got my laser on e-bay. There are hundreds on there from really cheap to really expensive. Just pick the one you like. Here's a link you can get 6 for $22.72 http://tinyurl.com/rxww7e ...

Bob,
I use one (crosshair laser) all the time. Mine is offset from the spindle and programed so I just line up the laser for XY zero, hit the "Go to Laser Zero" button and the spindle is moved...

Mr. Jones,

I have a Xylotex 3 axis driver I will send you, free of charge. It is only rated at 2.5 amps but if you find the right motors, it will perform very well. It is a spare that I...

Joe,
That brings tears to my eyes, that is the one I helped you finish. It was a super nice sign too.

I would suggest watching some tutorials on Youtube like Neville said. Then cut some samples and start experimenting, it will give you confidence you need to get you going. You'll learn more as you...

Very nice work Butch. I haven't found any part of the Sculpt Nouveau processes that I don't like. It's fun to work with huh.

Thanks, Joe. It was a pleasure to get to help you out and also a tremendous learning experience. I'll see you again soon.

Leon

Looking good Joe!

Precise Bits has these.
MM208-0625-050F

Pretty cool stuff. Nice work!

Thanks Joe.