Pictures continued. Again, this is not the only way or even the best way but this is what is working for me and has given good results. Good luck.
Type: Posts; User: robert_marks
Pictures continued. Again, this is not the only way or even the best way but this is what is working for me and has given good results. Good luck.
Eric – I have a small shop and mostly produce v-carved signs. As already mentioned I also use an Avery Paint Mask and machine through it for my lettering. This is a very simple process that works...
Bill, I also have my ShopBot in the basement so I know the noise is a real problem. As far as the cables they are in a e-chain that run along the back of the machine. The original arch broke several...
Bill, I also have a bench top that I have modified. I attached a larger mdf sub panel just below my spoil board to keep some of the cut material from building up under the machine. This does affect...
Ralph, nice machine! I have not seen one like that. It would be great if there was a place on the forum to share these machines. I am sure there are allot of older bots out there still working hard...
Thanks Brady,
This little bot has been a great machine, works hard, cuts clean and has taught me a great deal about CNC. There is always a learning curve when dealing with new machinery,...
I ran a search of the posts and found few if any upgrades to the PRT Benchtop. I know they are a little older machine but very capable and worth upgrading. I have made a few improvements as of late...