Search:

Type: Posts; User: Thom Dudley

Search: Search took 0.10 seconds.

  1. Replies
    90
    Views
    39,157

    i had this runnning months ago, but it doesnt...

    i had this runnning months ago, but it doesnt seem to function anymore. When I run the scan, nothing comes up. Firewall allows win remote, wifi is good, manually entering teh IP does nothing...As...
  2. Thread: Tab Error

    by Thom Dudley
    Replies
    2
    Views
    2,064

    Never miind - seems I had a space that was...

    Never miind - seems I had a space that was exactly .25", using a .25" bit. For whatever reason, in changing a separate vector, partworks no longer considered this clearance...acceptable? I guess?...
  3. Thread: Tab Error

    by Thom Dudley
    Replies
    2
    Views
    2,064

    Tab Error

    I am getting the following error:
    unable to transfer tab information from original vectors.
    Please ensure that the gap between all vectors is greater than the tool diameter to create tabs.
    Check...
  4. Replies
    6
    Views
    3,407

    I get the same problem in wood - rastered ...

    I get the same problem in wood - rastered pocketing does a light perimeter cut, but I don't like the surface it creates. Is there an easy way to make it go back for such a cut, r does it require...
  5. Replies
    3
    Views
    2,196

    Extremely helpful! Thanks!!

    Extremely helpful! Thanks!!
  6. Replies
    3
    Views
    2,196

    Tippy gantry

    We have a 4'x8' PRS standard that has been getting moderate use for the last 6 months. I noticed yesterday that while cutting pockets with the .5" straight bit, it leaves little tool marks at the...
  7. Replies
    4
    Views
    3,189

    Thanks y'all! Perfect!

    Thanks y'all! Perfect!
  8. Replies
    4
    Views
    3,189

    V-carving chip off

    I've started cutting little pyramids with the V-carving bit, running in straight lines that cross (see image below). The bit runs up one vector line, then comes back down to finish the cut, then does...
  9. Replies
    3
    Views
    2,884

    No, though making molds was a big selling point...

    No, though making molds was a big selling point for the bosses when we got the shopbot. We have boxes of blank decks left over from a project, so we're trying to find ways to mark them. Laser...
  10. Replies
    3
    Views
    2,884

    Machining on an existing surface

    I know there's a way to do this, but it's stumping me. The hive mind here is excellent, so here's the problem:
    We have a scanned model of a skateboard which we want to machine on a 3-axis PRS - the...
  11. Replies
    15
    Views
    13,649

    Roney, where in Brooklyn are you?

    Roney, where in Brooklyn are you?
  12. Replies
    15
    Views
    13,649

    Wow, thanks for the great advice everyone! I'm...

    Wow, thanks for the great advice everyone! I'm definitely feeling better about this....
    Our background is that we just bought a PRS Standard 48x96 after feeling like we were outgrowing the 18"x32"...
  13. Replies
    15
    Views
    13,649

    Registration & alignment

    Hi! I'm new, so do forgive if I've put this in the wrong place...
    This might seem like a daft question (a search brought up very little, so I'm likely missing something, somewhere...), but how does...
Results 1 to 13 of 13