Search:

Thank you Kenneth....... I'll have to look at my frame,,,,, but it never seemed to me that mine wobbles much. Maybe I run things too slow............ Chuck

Hello Kenneth. I am still fiddling with some other parts of my Bot, so I haven't yet been able to test out my welded gantry. When you did your gantry welding, how would you rate the improvement? ...

Thank you Dave. I appreciate your positive feedback. Best regards, Chuck

Thank you Brady!

Speaking of "riser blocks", while I have of course welded the 1.5"x 2.5" rectangular steel tubing to the 3" square steel tubing, I did not weld the long angle iron pieces to...

Part 3
Then I put the X carparts back on my Shopbot X rails, and fumbled around to get the longbrackets bolted on to the 3” square tubes, to restore my nowadjustable X motor carriers. (Picture I)....

Part 2
And then because thelong angle brackets were attached by bolts to the bottoms of the 3”square tubing, I was free to move the X gantry until it was in factsquare to the X rails. (Picture E). ...

Hello Shopbot Friends. I had to break this into 3 posts, with 4 pictures being the limit for any one post.



Part 1
Last September, in a quest to improve the rigidity of my X Gantry, I...