Search:

Type: Posts; User: Jay K

Search: Search took 0.63 seconds.

  1. Replies
    3
    Views
    518

    Setting a toolpath's ending point

    Sorry in advance if this is obvious information or has already been discussed a million times.

    I use my Desktop Max to build electric guitars, using multiple bits within a build. Is there a way to...
  2. Replies
    4
    Views
    7,041

    This just happened to me last night, except on...

    This just happened to me last night, except on the X axis.
  3. Replies
    5
    Views
    2,191

    Both methods seem straightforward. Thanks to both...

    Both methods seem straightforward. Thanks to both of you for your advice!
  4. Replies
    5
    Views
    2,191

    Thank you for your quick response. Let me make...

    Thank you for your quick response. Let me make sure I'm going to do this correctly. I just manually move the bit until it touches the Z-plate. Then, I just set the Z to .127 using the VA command?...
  5. Replies
    5
    Views
    2,191

    How to zero a diamond drag bit

    Hey folks,

    Relatively new user of a Desktop Max. Just purchased a diamond drag bit for engraving on nickel-plated stainless steel and set up the operation in V-carve.

    I'm at a loss how to zero...
Results 1 to 5 of 5