Still available
Price lowered to $400 cash
Type: Posts; User: kra
Still available
Price lowered to $400 cash
Price lowered to $400 cash
palatalizing is not a problem, but no way to get around shipping cost
yes
it is pretty heavy. would have to be motor freight
this is still available. will sell for $500 if anyone is interested
Spencer Vortex Regenerative Blower / vacuum
model# VB-055 (current model, accessories and parts readily available)
perfect for a vacuum hold down top on your cnc router
7.5 HP 3 phase TEFC motor...
this item is sold
couldn't figure out how to edit my post but price is $5400
PRT standard
4g controller
4' x 8' bed
current software and firmware
windows 7 pro 64 bit computer (fresh install)
good condition
(no spoil board currently installed. Getting ready to install...
pm sent
thanks
does it have the red drivers or the black ones?
pic?
would you consider $400?
interested in the 4g if it is still available
thanks
SOLD
thanks
SOLD
thanks
sale pending
and a few more pics
here are a few more pics
PRT Alpha 4x8
Colombo 4 hp spindle with Yaskawa V1000 drive running single phase
spindle recently serviced with new bearings, etc. (just a few hours run time since serviced)
4 zone vac table...
here is a link to all manuals, etc.
http://www.parkermotion.com/manuals/S-SX/S-SX.htm
another pic of model #
I have 5 Parker/Compumotor SX8 microstep drives for sale
I was told they were all in working condition but 2 of them needed fuses (these 2 are marked). they have internal fuses that fit in fuse...
probably obvious but i also start cut from side and move into part keeping z the same throughout cut and park spindle out of the way for loading next part always keeping z the same (in my case 0 )...
wayne
i cut approx 1/16" oversize and let the edge profile bit clean it up to exact size
my jig is just lightweight mdf with vac pulling strait thru from normal vac table
no special gaskets or...
wayne,
i cut a similar edge profile but much thinner material on a regular basis using a raised jig just made slightly smaller than piece being cut (actually larger than piece being cut but a trough...
also make sure your bit is not painted on the bottom keeping it from making contact
I use a bit from one company and they are always painted and I have to sand off the paint to z-zero