Search:

Type: Posts; User: Rick Reese

Search: Search took 1.20 seconds.

  1. Replies
    4
    Views
    9,930

    I held off at first on the upgrade because I...

    I held off at first on the upgrade because I didn't see the value for the few new features included with it. The new Photo V-Carve is nice, but I have a laser for that. Most of the changes in Version...
  2. Replies
    4
    Views
    9,930

    That did the trick. I appreciate your help. ...

    That did the trick. I appreciate your help.

    Rick
  3. Replies
    4
    Views
    9,930

    Problem with Version 10 post processors

    Just upgraded to version 10.0 and now I have only two post processors for Shopbot (both for tool change). I've tried the migrating function under the "help" section, but it did not bring them over...
  4. Replies
    4
    Views
    5,798

    Thanks to everyone for the helpful information....

    Thanks to everyone for the helpful information. I'm going to try the 3D modeling approach first.
  5. Replies
    4
    Views
    5,798

    Creating recess to hold a sphere

    A fellow shopbotter has asked for my help in creating a 2-part solid box to house a sphere shaped puzzle. He wants the box split in the middle with the lid held in place by magnets. The sphere is...
  6. Replies
    5
    Views
    3,441

    Thanks for the tips. I'll give it a try this...

    Thanks for the tips. I'll give it a try this weekend on a few test pockets.


    Rick
  7. Replies
    5
    Views
    3,441

    Need help with texturing pockets

    I 'm in need of some suggestions on tool-pathing a texture at the bottom of a pocket. The texture needs to blend into the radius at the botttom of the pocket without the tool touching the edges of...
  8. Replies
    5
    Views
    7,074

    Thanks for the tips Brady. I was wondering why I...

    Thanks for the tips Brady. I was wondering why I wasn't getting a spindle speed in the display. I actually got the machine powered up about an hour ago for the first time. I was a little nervous...
  9. Replies
    5
    Views
    7,074

    Spindle Speed USB

    After pulling off the cap, I did see that it is a male connector. It's been a long day but I'm almost ready to power it up for the first time. I appreciate your quick response and all of your helpful...
  10. Replies
    5
    Views
    7,074

    VFD Connection Question

    I'm just finishing up the assembly of my new 48x96 Standard. I'm attempting to connect the Yaskawa VFD to the 2.2 HP spindle. I've been over the documentation several times and did several forum...
Results 1 to 10 of 10