Search:

Type: Posts; User: hespj

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    5,599

    Finished this back in April, two years after I...

    Finished this back in April, two years after I started this thread! I wasn't cutting full time - it just felt like it. Slow, noisy work. I would go into the office and draw whilst the ShopBot cut,...
  2. Replies
    5
    Views
    5,599

    Thanks Brady. Yes, it'll need 9 sheets at...

    Thanks Brady.

    Yes, it'll need 9 sheets at least. Good job I'm not paying.

    But I see the scrap price is quite good. :D I've already got about 100lbs of swarf, and then there are offcuts. In the...
  3. Replies
    5
    Views
    5,599

    Looks like it is possible. I've now cut 18 of the...

    Looks like it is possible. I've now cut 18 of the 48 pieces. I'm machining the "slot" (approx 1.25 hours each), engraving some identity info on the inside of the slot (5mins), then profiling them...
  4. Replies
    5
    Views
    5,599

    Brass - machining a large slot

    What do you think the chances of me being able to machine the brass item shown in the attached images is? The piece is about 5' long (1500mm) and has a 4" (100mm) wide by 0.08" (2mm) deep trough...
Results 1 to 4 of 4