is it possible ? or do i have to erase the sections in the g-code editor that i dont want ?
i have a file 260 000 lines long and only want to run a certain section of it , do i have to trial and...
Type: Posts; User: Blackrat
is it possible ? or do i have to erase the sections in the g-code editor that i dont want ?
i have a file 260 000 lines long and only want to run a certain section of it , do i have to trial and...
Scott !! thanks for the help !!
its working at last , after a few hours on the post processor i can get decent g-code to do the job !
still got a minor problem on 'circle being to small' but i...
wow scott it works !!!
but how do i change the post processor ? and more importantly that i can change it back again
i dont fancy going thru 300000 lines of G code searching out them lines...
this is the same file as above in the pics ....
aaah, never thought about the version of SB ...
can i send someone a sbd file and see if it has the same problem ?
or is it possible to load it up here and just change to .txt ?
i have the originals, i just dont know how to write G code for shopbot from camworks ... whats super frustrating is that it 'almost works' .....
this shows typically what happens ...
That's the problem ... A few files have worked but the majority don't
I have tried converting to igs/step file and then doing toolpaths in vetric , but the quality is useless ....
Gutted
Hey all
A question I think I know the answer to , but in this day age I dunno anymore ;-)
Do I have to regenerate all my mach3 cut files ? Or is there a way that I can convert them so shop bot...
Hey all
Anyone got this working?
Or know where to get a post processor ?
Ta