Search:

Hi folks, I am looking for a shopbotter with a laser scanner in virginia that would be willing to scan some previously cut pieces of ours. We no longer have the tool paths and are looking to...

hey thanks Dan!

The thing that is holding me up is the 7 SCFM at 100PSI of clean, dry, un-oiled compresse notation - did you match these specs or are you running something different?

Hello All -

Can anyone recommend a good compressor for the ATC? ShoBot is spec'ing:

7 SCFM at 100PSI of clean, dry, un-oiled compressed air at a minimum with tubing no smaller than 3/8"...

Hello everyone - good to be back in the forum again!

I'm a former shopbotter looking for some assitance with cutting some small pieces. If there is someone out there who can help me with the...

Thanks Jeffrey - I did download a trial version of aspire but have not had a chance to really run it yet. Ill let you all know how it goes.

Hi Everyone - I recently moved my PRT 96 to a new shop and am ready to "plug it in" so to speak. Being a complete rookie to electrical - can I simply plug in this single phase machine? I had an...

Does anyone know how to install the spindle control wire? I'm setting up my new PRTalpha with porter cable router. Can't seem to find any info in the manual about the wire? this wire was in the...

Folks, could use some help here with wiring. Would appreciate advice on if I have this set up right before I turn my shopbot into an expensive smoke machine.

I'm wiring the outlet for the...

All, I am looking to buy the 4x4 table. I craft very detailed displays out of HDU. Please see http://www.gorgetdesigns.com/regimental.php?cat=3. Do any of you see any problems with the shopbot...