Tried the suggestions but have not come up with a solution to the X-axis chatter issue. :confused:
There is an issue that sticks in my head and makes me think it could be the X motors. I was told...
Type: Posts; User: Ken M
Tried the suggestions but have not come up with a solution to the X-axis chatter issue. :confused:
There is an issue that sticks in my head and makes me think it could be the X motors. I was told...
Set pinions into rack with a scale to make sure we have recommended pressure into rack. What is curious is I only get this serration in the X axis not in the Y.
Ran motors off the rack, checked for...
Serrated edges on all cuts on hdpe. Did not change feed and speeds which have been working fine (some serration of edges but usually only in curves and even then not to this degree). Checked square...
I have the same issues as QMI and have gone through ALL (I think) the steps recommended. For my PRS Alpha the worst chatter is in the X-axis. It is perplexing to say the least. It really showed up...