Search:

Thanks Brady and Joe

Is this the correct software for the digitizer? Looks like it was for other uses.

I need to get software for a immersion microscribe 3d. Anyone know if there might be a free download somewhere or suggestions. Thanks

What is the name or type of material that you see used to make the plastic
Adirondack chairs??????? Perhaps this is the same or similar to the decking materials.

Thanks for everyones input.

I am making balusters for porches. Normally I make them in wood for painting. Someone wants them in a synthetic/plastic so they do not have to paint them forever. I can do pvc. I am concerned...

Thanks Brady for responding to my question. I will give that a try. The problem comes and goes but when it comes it is a pain. Parts on the table when it happens are no good most of the tome.
...

From time to time my Y axis seems to loose it's place a little and give me steps as it does it various passes to get to full depth. It seems like this happens the same time that my motor begins to...

I am completing a vaccum system with Gast pump with tank. I wondering what type of hoses are required to go from my tank to the jig with gaskets. Will air hoses and connectors used for compressors...

Steve thanks, I am not familiar with brand names but I think that is the material. The outside is pretty hard but the interior is softer and you can
dent it with you fingernail. I looked up...

I have a request from someone to make some large decorative porch brackets at approx 26 x 26. I make smaller sizes in wood but concerned that this size is large enough to potentially have some...

I have a request from someone to make some large decorative porch brackets at approx 26 x 26. I make smaller sizes in wood but concerned that this size is large enough to potentially have some...

Am I cutting to deep? I have a bt48 prs with standard motors and router.
I was recently cutting some 2.25" thick basswood. I was cutting with a .5 inch downcut bit and each pass was approx .43...

Thanks Mark, Looks like I have version 1. So that is probably why I don't have that tool.

I think I have partworks version 2. What I have is version 3.0.2.0.
Is there just one newer version than this? Is there a lot of difference?

Regarding my previous post on 2D probe files having less than perfect edges.
Scott mentioned to try using the tool in partworks "fit curves to selected vectors" I can't seem to find that. I think...

Thanks for your advice. I looked in the tools in the version of PW I have and did not see
a choice of "fit curves to selected vectors" I think the version I have is 2 and there is a 3 now. Do you...

I posted last week about what I called edge chatter on a 2D profile cut. Thanks to everyone who made suggestions. I 2D probed a Victorian style baluster and then spent several hours going back...

I'll reply to several of your comments in this email. Thanks for your help.

The 52-701 was recommended to me by the maker. They said it was for plastics but worked good in soft wood but it...

Starting to cut some wood with a bt48 I purchased used. I am cutting a baluster for porches that has many curves. I am cutting 3/4 cypress which is fairly soft. I am cutting 1/4 deep each pass @...