Anyone have a horseshoe RLF or Vectors
to share?
Thanks, Waltie
Type: Posts; User: waltie
Anyone have a horseshoe RLF or Vectors
to share?
Thanks, Waltie
Does anyone have a relief or vector drawing
of an Indian Peace Pipe?
Thanks, Waltie
Thanks Butch
Anyone have a barrel racing relief they would
be willing to share? Want to make a gift for a
sister.
Thanks Waltie
Does anyone have a roof tile texture they are willing to share? Perferably oriental style
Thanks in advance
I will be cutting out large letters for a sign company. I was thinking of using a 1/4 upcut bit. the foam is only .780
would 8ips at 10,000 RPM give me a good finish
with no melting?
Thanks,...
What is the best RPM & feed rate for cutting
pink insulating foam? Thanks
Anyone have a rose relief that they would like
to share?
thanks
It is glued down, so my only option appeares to machine it.
Thanks for your help
My vaccum board made of Sinta PVC is wavey, I
need to surface it. My question is at what speed & feed do I run my 1 1/4 surfacing bit?
My max depth of cut will be about .100 in places,
can...
Part done in AutoCad, using Arcs post MM, and using 3/16 spiral O bit, only bit I got, here is
a picture of the part (I Hope)
8817 (30.7 k)
I thank everyone for their help, now a new problem. I am getting bad chatter marks all around this part. How can I get rid of these, or
can I?
Brady, The AL is gluded to 3/4 MDF, so the water issue is not a problem. I had to do this because the parts are about 1.750 X 1.750, Very small to hold down otherwise.
Single Flute
I am trying to machine 1 mil al sheet, using a Onsrud 3/16 UpcutSpiral O bit,16,000 RPM with a feed of 1.3IPS, also using a mister. I am getting weld of the chip to the material.
What am I doing...
Does anyone have DXF files of knock-down childrens furniture or toys they would like to share.
Thanks
How can you check for leaks in the vacuum system?
I have a 5hp - 6 zone system
I want to engrave a design onto a piece of cooper,
but I don't know what type of router bit to use or
the depth I need to go for a good look. Speed and
feed will also be very helpful. I have a...
John, I do my lithos at .160, gives great results
I display mine light to the flat side
I rented a Laser Level, to level the table and the X-Rails.
Worked Great
Gerald, now that will work, but the X proportion is 1.010
Just tested it
Thanks
I got a big problem and I need some help guys.
I created 92 toolpaths, then found that I used the wrong Z depth. 5MM instead of 6MM.
My question is, after zeroing can I move the Z to -1.0MM...
Thanks Mike,
will give it a try
How can I seal the machined surface of MDF before painting?
I cannot sand the project that I'm doing because of the design. Using steelwool is my only option.
Any help will be appreciated, ...
Thanks guys for the help
the RPM of 16,000 and a feed rate of 1" in/sec
did a great job
Thanks