I will give that a try. Thank you!
Type: Posts; User: matt_raymond60
I will give that a try. Thank you!
Good to know! Sounds horrible but is cutting nicely. Happy to have in action again. Thank you!!
Just a quick note that I am up and running. With your help I didn’t give up. Not 100% sure I am using the correct SB file, but it works. Made a separate post about a weird noise when cutting v carve...
Just started using my older 48 by 96 PRT Shopbot recently after it sitting for a few years. I did the upgraded card a long time ago where it uses the USB cord between the computer and controller....
More good info! Thank you!
Thank you Wayne! That helps a lot!
Thank you for all the replies. First and foremost, I think that VCarve Pro was a bargain at $700. I really want Aspire and will upgrade within a year I am guessing. When I was looking at upgrading my...
Bringing my Shopbot back to life after a few years and my old ArtCam program was obviously dead to the world so I bought VCarve Pro thinking that was a good move with the intention of upgrading to...
Thank you both!
My 2002ish PRT has been moved around a lot since last used and I would imagine it needs to be tuned up although since it is a heavy welded frame I can’t imagine things moving in relation to each...
Can this be used on all models or just ones with the ATC?
My Shopbot has been pushed off in a corner of our cabinet shop for several years and it is time to put it back to work. This is a 2003 PRS Standard with just a PC router as far as I know. I did the...
Any particular model you are looking for? I have an older 4 by 8 PRT Standard up in Little Elm that I may consider selling.
This has been sold...
Been a long time since I used this, I am still looking for the PC that I used to drive the Shopbot computer. Shopbot computer was upgraded to the 4g version the last time I was using it. Shut down...
Has anyone built a Texas Star cutting file that I could beg, borrow, steal, or even buy? It needs to be about 4 1/2" in diameter with the center of it about 1/4" thick.
I am not at the shop where...
Great, thanks! I am going to cut some this week to see how it goes. I have a small new bar area in our hallway that is topless at the moment. As much as I enjoy that, it is time to cover it up. :( ...
Does anyone have experience cutting Avonite or any of the other similar solid surface materials on the Bot? If so, how did it work out? Any tricks to pass on?
So you either of you use the shim method for very minor adjustments or how do you do it? Using a 1 1/4" bit for surfacing the ridges were only about 1/32" or so high...
Got the newly upgraded Bot running today, runs great when I don't do stupid things!
When I was surfacing my table I noticed that my router is ever so slightly off in alignment. The top of the...
Thank you!
So the relay that was used before won't work with the 4g board?
I was just looking at the connections. The connection that was already wired up that I used has the wire for the relay in the #4 output position. Looking in the book it seems that would activate the...
One more quick question. The previous system setup started the router for both jog and move functions. As of now the router doesn't come on for either function. I am trying to figure if there is...
The second hand, unused router that I bought on here came with the Shopbot mount, it is MUCH better than the homemade one that came with the machine when I bought it. I think that some of my earlier...